The Single Best Strategy To Use For audioflow walkthrough

Added crashed customer detection and shutdown code. If a consumer crashes, when gatherings are despatched to it and so they are unsuccessful as a result of precise problems, we shutdown that shopper and terminate them.

Preset bug for recursive deal with entries. If discovered, the recursive portion is taken off leaving an deal with which might be invalid but stops a crash.

Added new critical per segment: RunAsSingleTransaction. This starts off a transaction to allow all deferred reboots to carry off right up until the end among other optimizations. See reference docs for complete facts.

Set many crashes when sign states for serials of ~200 figures or more would crash the debugger, incoming or outgoing.

Bug in minimal-amount "ReadUntilNoDataTimeout" perform which garbled facts by not clearing the buffer amongst Each and every channel RX contact.

Extra a check in subnet detect code to only contact secondary detect potential Should the session supports it. this was performed to take care of the XGen appropriately.

Deal with for SIMPL Debugger where reloading a improved software, all indicators commenced tracing, not exactly what was prior to.

Preset bug wherever HW circulation Handle settings may be misplaced In the event the cable wasn't connected. Library overrode settings but by no means set them back again right up until the port was re-opened.

Seed correct values for passthru params and ensure the popup more info demonstrates them appropriately when initialized.

In CSession::StartAutonomousAction, added a phone to ProcessMessages(0) just ahead of the wait to allow processing of any pending messages previous to ready.

NEW Toolbox does not guidance concurrent use by many people over a Computer. In otherwords, you cannot run Toolbox underneath one consumer then use the Home windows switch person purpose and run Toolbox below the other consumer too.

Adjusted "progcom" to the complete command "progcomments" as a way to disambiguate it from any long run commands.

Set some faulty failures sending data files to three-Series equipment determined by incorrect dimension limitations.

" due to the fact that does not operate properly in FW.